Teltonika 4G-RUT240 Compact Industrial 4G LTE Router

Product Information

The transmit power of an access point radio is proportional to its effective range – the higher the transmit power, the more distance that a signal can travel, and/or the more physical materials that it can effectively penetrate and still have data successfully resolved at the receiver. Fixed vulnerabilities CVE-2022-3524, CVE-2022-3566, CVE-2022-3567, CVE-2022-39188, CVE-2022-45934, CVE-2022-47929 There is currently no 5G router option available from Teltonika. However, it is expected that Teltonika will shortly announce the launch of a new 5G M2M Router, maybe just a re-hashed RUT950 router with a 5G modem inside, or maybe one of their office 5G routers like the RUTX12 with a 5G modem. When they have a 5G router it will be ideal for 5G CCTV, Office 5G router connectivity or high speed 5G Internet ideal for use as homeworker 5G router solution. IKEv1, IKEv2, with 14 encryption methods for IPsec (3DES, DES, AES128, AES192, AES256, AES128GCM8, AES192GCM8, AES256GCM8, AES128GCM12, AES192GCM12, AES256GCM12, AES128GCM16, AES192GCM16, AES256GCM16) Note: Interface(s): lan have mtu lower than 576 it will make all interfaces on same physical interface no longer support DHCP.

The Fast Roaming tab is only available when in General setup section Client mode is selected and in Advanced settings tab Enable fast roaming option is enabled. The CA file generated with this option automatically signs the certificates. In short, this option is used for convenience as it doesn't let the user set any additional parameters for the certificate files. Therefore, it should be used only when no other specific requirements are expected. The figure below is an example of the Flash New Firmware Image section and the table below provides information on the fields contained in that section: Maximum time (in seconds) the button can be held to perform an action, after which no action will be performed. Always use 40MHz channels even if the secondary channel overlaps. Using this option does not comply with IEEE 802.11n-2009!

The General section is used to set up some of device managerial parameters, such as changing device name. For more information on the General section, refer to figure and table below. The SSIDs section is used to configure your wireless access points (AP) and wireless clients (STA). The routeris supplied with 2 x WiFi antennas, 2 x cell Antennas, 1 x Patch lead and 1 x UK Mains Power Adapter.

Specifies whether DHCPv6 server should be enabled (server), relayed (relay) or disabled (disabled). When you upload a firmware image, the device will have to verify the validity of that image. If the verification was successful, you will be redirected to window with a message such as this:

Because this is an industrial router designed for M2M remote management and monitoring it would usually be used with a Fixed IP SIM Card to provide convenient and reliable remote access to the router and connected devices. Teltonika RUT240 Compact 4G Router Applications.